Whole-Home Repiping in Rockwall, TX
When you have had three leaks in two years, the fourth repair is not the answer.
Plumbing
Whole-Home Repiping
Repiping means replacing the water supply lines throughout the house rather than repairing them one failure at a time. It is a significant job and nobody should be talked into it casually — but there is a point where it is clearly the cheaper decision, and plenty of homeowners pass that point while still paying for spot repairs.
The honest test is simple. If you have had multiple leaks in different places within a couple of years, if your water runs discolored on the hot side, or if your home still has galvanized steel or polybutylene supply lines, the system is telling you something. Each individual repair is reasonable. The sequence is not.
We work in stages so your water is on at the end of every day, and we cut access thoughtfully rather than opening everything at once.
When you need repiping
The symptoms homeowners actually describe when they call us — and what each one usually means.
Leaks in different places, close together
One leak is an event. Three in two years, in unrelated parts of the house, means the material has reached its service life and the failures are going to keep coming. You are not unlucky.
Discolored or metallic-tasting water
Brown or yellow water — especially after the house has sat unused — points to corrosion inside the pipe itself. Galvanized steel corrodes from the inside and sheds into the supply.
Pressure that has slowly declined for years
Corroding galvanized pipe narrows internally. It happens slowly enough that people adjust to it. If your shower is noticeably weaker than it was a decade ago and the pressure regulator checks out, the pipe is the constraint.
Polybutylene supply lines
Grey plastic pipe common in homes built roughly from the late 1970s into the mid 1990s. It has a well-documented history of failing at fittings, often without warning, and many insurers treat it as a known liability. If you have it, plan for replacement rather than waiting.
Repeat slab leaks
A second slab leak in the same home is a strong signal. Rather than opening the concrete again, repiping through walls and attic takes the supply system out of the ground entirely.
What actually happens on the job
No mystery, no vague diagnosis. Here is the sequence we follow every time.
Full assessment first
We identify the pipe material, check pressure, inspect what is accessible, and look at your repair history. Sometimes the answer is a partial repipe of one problem run, and that is a legitimate outcome of the conversation.
Plan the routing
Modern repipes generally run through walls and attic rather than under the slab, which means future repairs never need concrete work. We map access points to minimize drywall and to avoid the finishes that are expensive to restore.
Stage the work
Rough-in, then transitions, section by section. Water is restored at the end of each day. We are not leaving a family without water for a week.
Pressure test, inspect, and close up
The full system gets pressure tested and, where the city requires it, inspected before anything is closed. Then drywall patching and clean-up.
Which North Texas homes are on the clock
Housing age tells you most of what you need to know. Homes built here before roughly 1970 may still have galvanized steel, which corrodes internally until pressure and water quality both suffer. Homes from the late 1970s through the mid 1990s — a huge share of the stock across Garland, Rowlett and older Dallas neighborhoods — are the polybutylene window, and those fittings fail without warning. Homes from the 1990s and 2000s across Rockwall, Wylie and Plano are typically copper, which is durable but vulnerable to pinhole corrosion from our hard water over a couple of decades, particularly on hot lines. Our clay soil movement stresses all of it. Knowing which category your house falls in is the difference between planning a repipe and reacting to one.
Straight talk on pricing
A repipe is priced by the size of the system, not by the hour — number of fixtures and bathrooms, one story or two, slab or pier and beam, attic accessibility, and how much finished surface has to be opened and restored. It is a real investment. What we will do is give you a fixed number after seeing the house, and tell you honestly if a partial repipe of one failing run gets you most of the benefit for considerably less.
(469) 338-5533Repiping questions we get asked
How long does a whole-home repipe take?
For a typical single-family home, usually a matter of days rather than weeks, with water restored each evening. Two-story homes, larger fixture counts and difficult attic access extend it. Drywall repair and paint run after the plumbing is signed off. We will give you a real schedule before we start.
PEX or copper — which should I choose?
Both are good systems and we install both. PEX is flexible, resists freeze damage better, needs far fewer fittings, and installs with less demolition — which is why most modern repipes use it. Copper is rigid, extremely long-lived, and some homeowners simply prefer it. In our hard water, PEX has an edge on pinhole corrosion resistance. We will walk through the trade-offs for your specific house rather than pushing one.
Do I have to move out?
Almost never. We stage the work so the house stays livable and water is back on overnight. There is dust and there is noise, and access holes in walls and ceilings while it is underway, but people generally stay put.
Is it better to keep doing spot repairs?
Sometimes, genuinely. If the pipe material is sound and you have had one unlucky failure, repair is the right answer and we will say so. The math changes when the failures are repeating, when the material has a known end-of-life problem, or when each repair means opening concrete. Add up what you have spent on plumbing in the last three years — that number usually makes the decision obvious.
What Rockwall neighbors say
"Fastest to respond and complete the job — a must when you wake up to no hot water on a cold morning. They cleaned my tankless water heater and had everything running perfectly."
"A great partner for both plumbing and HVAC. High-integrity company — responsive with questions, they show up on time, and their prices are reasonable. Exactly what you want."
"Fantastic. Great job for a fair price, responsive and professional the whole way through. Highly recommend Wilson Family for any plumbing work."
"Fair estimate and they went beyond to sort out the city requirements for us. Kari was incredibly responsive and Tyrone was professional and right on schedule."
Repiping across Rockwall County & the Dallas metro
Same licensed team, same 24/7 phone, every one of these communities.
Related services
Worth reading first
Everything we do
Book Wilson Family — one call fixes plumbing, heating & air.
Upfront pricing, licensed technicians, and a family that treats your home like its own. We answer 24/7.